• Class and Course

    Hydraulic Control Panel

    The oil and gas plant controls its oil or gas well through a Wellhead Control Panel (WHCP).  Each well is always equipped with Surface Controlled Sub-surface Safety Valves(SCSSV) or usually it is called as Down Hole Valve (DHV) and  Surface Safety Valves (SSV) which consist of a Master Valves (MV) and Wing Valves (WV).  SCSSV in most application is an on-off valve with hydraulic actuators.  While SSV can be driven by hydraulic actuator or pneumatic actuator depending on the pressure rating. There is also a need to open or close SCSSV and SSV in sequence and accommodate an Emergency Shutdown signal from the systems.

    WHCP systems usually consist of hydraulic reservoir, strainer, hydraulic pumps, accumulator, wellhead control module, and hydraulic lines.  Any other parts, except wellhead control module, are housed in a basic cabinet.  Each control module is built up dedicated for one well only. Therefore, if there are five wells in a wellhead platform, then there will be one basic cabinet and five wellhead control modules.

    This course provides the necessary knowledge for the participants to become familiar with the principles of oil well hydraulic control panels. Routine, emergency operation, and associated features will be examined while stressing process, safety, and environmental compliance and concerns.  Case studies will be utilized to reinforce the material covered.

    Day 1

    Wellhead Valves

    • Types, construction, and operation
    • Hydraulic panel connections to the wellhead
    • Single and multiple wellhead panels

    On day one, participants will gain a thorough understanding of the types, purpose, construction and operation of wellhead valves as found in today’s oil and gas industry.  Proper hydraulic panel connection for single and multiple wells will be discussed. Routine, emergency operation, and associated features will be examined while stressing process, safety, and environmental compliance and concerns.

    Day 2

    Wellhead Panel Hydraulic Systems

    • Supply systems and components
    • Wellhead control instrumentation
    • Hydraulic control system

    On day two, participants will gain an understanding of wellhead hydraulic systems, their components, and control system.  Process flow and Process and Instrumentation Diagrams (P&ID’s) will be reviewed prior to covering the hydraulic control system operation for normal and emergency situations.  Process, safety, and environmental compliance will also be stressed.

    Day 3

    Hydraulic Wellhead Control Panel

    • Hydraulic switches, valves, and pressure monitoring
    • Disassembly and assembly of a hydraulic unit
    • Operation, maintenance, and testing of a hydraulic unit

    On the last day, participants will gain a thorough understanding of the system components, assembly, disassembly, and testing to ensure proper operation.  Testing procedures of the unit to ensure that it is operating properly after repair will also be reviewed.

    This course is mainly targeted to instrumentation technicians working in the field as an introduction or refresher.  The course can be applicable to technicians working in other disciplines, equipment purchasers, procurement and storage personnel, job planners, and immediate supervisors.

    Anyone taking this course should have some exposure to an oil and gas facility terminology.

    Currently there are no scheduled classes for this course.

    Click below to be alerted when scheduled

    Set a training goal, and easily track your progress

    Customize your own learning journey and track your progress when you start using a defined learning path.

    In just few simple steps, you can customize your own learning journey in the discipline of your interest based on your immediate, intermediate and transitional goals. Once done, you can save it in NExTpert, the digital learning ecosystem, and track your progress.
    © 2024 SLB Limited. All rights reserved.